Maple Bowl

Another bowl from Brandon and Sharon’s japanese maple tree. I gave this bowl to Sharon for her birthday.

It was rough turned and allowed to dry for several months. At first I turned a dovetail in the bottom but a weak spot caused it to break out while I was turning the inside.

So I filled the dovetail with a piece of turned 2 x 4 and epoxied it to the bottom and screwed a faceplate to it. And allowed it to dry/warp for another month. The maple had become very hard at this point and I was getting a lot of catches even while taking very light cuts and being very careful. I tried using a scraper to remove the gouges made by the catches and got catches with that – a very difficult piece to turn. I got a catch and the epoxied tenon broke off. So I made another one and glued it on and eventually, as a result of another nasty catch, it snapped off as well.

So I mounted it the Cole jaw chuck and turned the remainder of the tenon off and turned some of the bottom off so I could turn a ~4″ diameter tenon in the maple and reverse mount it in the 4 jaw chuck with new 100 mm jaws. (had been using 50 mm jaws before in expansion mode). After nearly giving up several times,  I turned the piece very carefully with a sharp scraper and fresh cutters on the EasyWood Tools (the rougher and the finisher) with very, very light cuts – it took a long time but in the end well worth it.  As with most things, persistence is the name of the game.

 

 

 

This entry was posted in Uncategorized. Bookmark the permalink.

One Response to Maple Bowl

  1. Sharon says:

    Wow, very interesting to hear about the process… I had no idea it was a months long project. Thank you again for the beautiful bowl!

Comments are closed.